2-11. Replacing the Lens Harness
Tools required Installation and removal tool (for bushing): Sony P/N J-6470-280-A n If it is not available, use pliers or a similar item. Removing 1. Perform steps 1 to 4 in Section 2-9-2 �CAM BODY Connector� to remove the IF-708N/708P board. 2. Pinch the cord bushing by the Installation and removal tool as shown in the figure and pull out the cord bushing in the direction of the arrow.
Installation and removing tool
Cord bushing
Installing 1. Attach the cord bushing to the lens harness as shown in the figure. n When attaching, ensure that the cord bushing is properly positioned and oriented with respect to the lens harness. 2. Attach the cord bushing to the front panel in the reverse order of removal.
Lens harness Cord bushing (top view)
226 ±5 mm
3. Install the IF-708N/708P board in the reverse order of removal.