2-12. PICTURE TUBE REMOVAL
NOTE: The picture tube for New Zealand model are upside-down, and the position for the anode-cap and tension spring is changed accordingly.
�REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
!£ Four DGC clip !� Demagnetic coil !� Four claws
�REMOVING PROCEDURES
RM-954
a
8 Chassis assy !ª Two screws (+P 3 � 12) 1 Two screws (washer head) (+P 4 � 16) 9 C board !º Neck assy !¡ Deflection yoke 3 Speaker (15 � 6.5cm) !¶ Two screws (Tapping) 2 Speaker (5cm)
a
1 Turn up one side of the rubber cap in the direction indicated by the arrow a.
!¢ DGC band !§ Tension spring !¶ Two screws (Tapping) 4 Two screws (washer head) @º Two screws (+P 4 � 16) (+P 3 � 12)
b b
2 Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
c
28 �
Anode button
7 Anode cap
3 When one side of the rubber cap is separated from the anode button, the anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c.
1 Do not damage the surface of anode-caps with sharp shaped objects. 2 Do not press the rubber too hard so as not to damage the inside of anode-cap. A metal fitting called the shatter-hook terminal is built into the rubber. 3 Do not turn the foot of rubber over too hard. The shatter-hook terminal will stick out or damage the rubber.
