Tip If you made a mistake, press CANCEL. The setting entered last will be cleared. Re-enter it.
5
Set the timer to the hour and the minutes you want to start recording. 1 Press = or + to set the hour and press DISPLAY ENTER MEMORY. 2 Press = or + to set the minutes, and press DISPLAY ENTER MEMORY.
6 7
Set the timer to the hour and the minutes you want to stop recording. (Do as step 5.) Press = or + to set the volume you want, and press DISPLAY ENTER MEMORY.
Tips � To exit the standby mode, press STANDBY twice to make the t indication disappear. � The preset settings remain until you reset them. � When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made. � The display window does not light while the recording timer is on.
8
Press STANDBY. The power goes off and the player enters the standby mode. The t indication and the recording side of the tape (front side ( or reverse side 9 ) appear in the display. To change the recording side, press STANDBY again. At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again.
To check/change the recording timer settings Press TIMER, then DISPLAY ENTER MEMORY. Each time you press DISPLAY ENTER MEMORY, a stored setting is displayed in the set order. To change the setting, display the setting you want to change and reenter it. To use the player before a timer-recording starts If you turn on the player, you can use it as usual. Before the preset time, tune in the station you want to record and turn off the power. To stop timer-recording Turn off the power.
The Timer
