SHARP SF2218
Manual de Usuario

COPIER TROUBLE?
Problem
Copier does not operate. Copies are too dark or too light. Blank copies. Copies smear if rubbed. Paper misfeeds frequently. Copier plugged in? Power switch ON? Copy density properly adjusted? Is the original placed face down? Paper too heavy? Paper damp? Non-standard paper used? Paper properly installed? Pieces of paper inside copier? Paper curled or damp? Dust, dirt, smudges appear on copies. Document glass or document cover dirty? Original smudged or blotchy? Is the d indicator on?

Solution
Plug the copier into a grounded outlet. Turn the power switch ON. See page 3-14. Place the original face down on the document glass. Use copy paper within the specified range. See page 3-28. Replace with dry copy paper. See page 3-28. Use standard paper. See pages 3-11 and 3-28. Make sure the paper is properly installed. See pages 3-3 and 3-11. Remove all pieces of misfed paper. See page 3-16. Store copy paper flat in the wrapper in a dry location. See page 3-28. Clean regularly. See page 3-25. Use a clean original. Developer is required. Contact your Sharp Service Centre as soon as possible. See page 3-25. Maintenance is required. Contact your Sharp Service Centre as soon as possible. See page 3-25. Wait until warm-up is complete. Warm-up time is 35 seconds. The copier is in the auto power shut-off mode. Press the print (z ) button. See page 3-24. The copier is in the auditing mode. Enter your account number using the 10-key pad. See page 3-15. indicator on? Copy paper is needed. See page 3-3. 1. Paper has run out in the optional multi bypass feeder. Add paper to continue. 2. Paper has failed to feed from the optional multi bypass feeder. See page 3-12.

Is the copy m indicator on? Power is on but copying is not possible. Is the m indicator blinking? Is the power save indicator blinking? Is only the POWER SAVE ( i ) indicator on? Is steadily lit in the copy quantity

display? Is the

x

Has a blinking

: appeared in the

copy quantity display? Is

steadily lit in the copy quantity 1.The optional sorter or staple sorter is not latched to the copier. Slide the sorter display? or staple sorter toward the copier to latch it into place. 2.The stapler cover of the optional staple sorter is open. Close the stapler cover. Is the t indicator blinking? Is the j indicator blinking? Toner is required. See page 3-5. A misfeed has occurred. See page 3-16. Close the front cover firmly.

D GB

Is the front cover firmly closed?

Please contact your authorised Sharp Service Centre immediately if a problem persists after checking the above.

3 � 26
SF 2218 NON EU GB+D.p65 26 27/08/99, 08:38