NAD S70
Manual de Usuario

menus. � In the Main Menu, press the button next to component displayed you wish to operate, e.g. "AMP". � The appropriate Component Menu and its icon appear in the top of the display, the "AMP" Menu in this example, with all available functions will appear. Press the button next to the function desired in the display. See also figure No. 5. � Press the button next to "EXIT" again to return to the Main Menu from where you can select another component. NOTE: If in System Set-up Menu "S170" was selected as "PREAMP" (refer to section " Set-up of the S70 remote control: S100 or S170 Preamp selection") additional sub-menus for SOURCE, LEVELS, OSD, MODE/MULTI.S and PRESET 1-5 become available. See also S170 menu, figure No. 6 and figures No. 6a through 6e for S170 submenus. In some Component Menus selecting a function will take you to another Component Menu. For example, pressing the button for CD in the Amplifier Component Menu will switch the input of the amplifier to the CD input and change from the Amplifier Component menu to the CD player Component Menu. These buttons can be recognised by the icon corresponding to the Component Menu. NOTE: You can set up and customise the NAD S70 to suit your particular NAD system. Refer to chapter "Set-up of the NAD S70 Remote Control". Main Menu: Viewing Timer status The S70 can be used to turn your system on and off at specific times with the Timer function. To set, activate or de-activate the Timer function, refer to chapter "Setting and activating the Timer". You can view the Timer status and engage from the Main Menu: � Select Main Menu by pressing "EXIT" in any of the other menus. � Press the button next to "TIMER" once. The display will now show the On Time and Off Time and which component was selected. The symbol on the right of the clock in the top of the display indicates that Timer function is activated. Refer also to Figure No. 7. � Press the button next to "EXIT" to return to Main Menu. NOTE: The Timer function in the Main Menu is available only if both Clock and Timer functions have been selected (indicated by tick-mark) in the System Set-up Menu. Refer to chapter "Set-up of the S70 Remote Control" for information on activating and setting the clock. Main Menu: Activating & viewing Sleep Timer status With the Sleep Timer function you can set the S70 to automatically switch off your system after a preset number of minutes to Standby mode (provided all components were in Operation mode, not in Stand-by mode). � To activate the Sleep Timer function, press the button next to "SLEEP". The clock in the display changes to show the time set for the Sleep Timer Function. It is now activated and set for 10 minutes. The symbol on the left of the clock in the top of the display indicates that the Sleep Timer function is now activated, regardless of whichever Menu was selected. Refer also to figure No. 8. � Each consecutive press will advance the sleep time in 10 minutes increments, up to 90 minutes. � To cancel the Sleep mode, continue pressing the SLEEP button until "OFF" appears in the display. 20