Before using ª Charging lamp Lights up: Charging Goes off: Charging completed Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start. When the battery temperature is excessively high or low, the [CHARGE] lamp flashes and the charging time will be longer than normal. ª Connecting to the AC outlet ª Attaching the battery Push the battery against the battery holder and slide it until it clicks.
ª Removing the battery While sliding the [BATTERY] lever, slide the battery to remove it.
BATTERY
1
�Hold the battery with your hand so it does not fall. �Before removing the battery, be sure to set the [OFF/ON] switch to [OFF].
1 Connect the AC cable to the AC adaptor and
the AC jack. 2 Connect the DC cable to the AC adaptor. 3 Connect the DC cable to this product. �The output plug of the AC cable is not completely connected to the AC adaptor jack. As shown in 1, there is a gap. �Do not use the power cord for other equipment since the power cord is exclusively designed for this Camcorder. Do not use the power cord from other equipment for this Camcorder.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer�s instructions.
