|
Usuarios conectados
Actualmente hay 6043 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
DESCRIPTION OF SCHEMATIC DIAGRAM
VOLTAGE MEASUREMENT CONDITION:
SCHEMATIC DIAGRAM
1. When the exclusive-use AC adapter is used, the colour bar signal of colour bar generator for service is input to get the normal screen. When the audio is minimized, the voltage value is measured with the 20 k�/V tester.
WAVEFORM MEASUREMENT CONDITION:
Model
LC-26GA3M/X/H
1. When the exclusive-use AC adapter is used, the colour density, lightness and colour hue are set to the center position, and the signal of colour bar generator for service is observed to get waveform.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR 1. The unit of resistance ��� is omitted. (K=k�=1000 �, M=M�). 2. All resistors are ± 5%, unless otherwise noted. (J= ± 5%, F= ± 1%, D= ± 0.5%) 3. All resistors are Carbon type, unless otherwise noted. C : Solid W : Cement S : Oxide Film T : Special N : Metal Coating CAPACITOR 1. All capacitors are mF, unless otherwise noted. (P=pF=mmF). 2. All capacitors are Ceramic type, unless otherwise noted. (ML) : Mylar (PF) : Polypro Film (TA) : Tantalum (ST) : Styrol
CONTENTS
Page DESCRIPTION OF SCHEMATIC DIAGRAM �������������������� D2 AV Unit ��������������������������������� D3 � D20 OPERATION Unit �������������������������������� D21 R/C LED Unit ��������������������������������� D22 DVI Unit ���������������������������������D23 � D24 PC CARD Unit ������������������������������D25 � D32 LCD CONTROL Unit ���������������������������D33 � D48 MAIN Unit ��������������������������������D49 � D76 POWER Unit �������������������������������D77 � D80 INVERTER Unit �����������������������������D81 � D82 INVERTER GROUND Unit �������������������������D83 � D84 CPU Unit ��������������������������������D85 � D94 EXT, SP Unit ���������������������������������� D95
CAUTION:
This circuit diagram is original one, therefore there may be a slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH �å� ( )ARE IMPORTANT FOR MAINTAINING THE SAFETY OF THE SET. BE SURE TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAINTAINING THE SAFETY AND PERFORMANCE OF THE SET.
D1
D2
|
|
|
> |
|