PHILIPS FW-M55/25
Manual de Usuario

TUNER
Storing Preset Stations
MINI HIFI SYSTEM
PROGRAM SHUFFLE REPEAT TIMER REC NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz

STEREO BACK FRONT HSD

STANDBY ON

RDS

You can store up to 40 radio stations in the memory. When a preset radio station is selected, the preset number appears next to the frequency on the display. Automatic programming 1 Press TUNER (BAND). 2 Press PROG for more than one second.

Manual programming 1 Press TUNER (BAND). 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press PROG for less than one second. � The PROGRAM starts flashing. � The next available preset number will be displayed for selection. 4 Press à or á to tune to the desired frequency. � If you wish to store the radio station to another preset number, press 4 or 3 to select the desired preset number. 5 Press PROG again. � The PROGRAM disappears and the radio station will be stored. � Repeat steps 3 � 5 to store other preset radio stations.

PROG
SEARCH � TUNING
DU (HSD B )

STOP�CLEAR

PLAY PAUSE

PREV SIDE NEXT

REC

-

ALBUM

+

SOUND MP3-CD NAVIGATION

-

INCREDIBLE SURROUND

DYNAMIC BASS BOOST

DIGITAL SOUND CONTROL

Note: � For 'EASY SET' feature, please refer to page 11.

� Repeat this procedure until the desired station is reached. � To tune to a weak station, briefly press à or á repeatedly until the display shows the desired frequency and/or when the best reception has been obtained.

Tuning to radio stations
1 Press TUNER (BAND) to select TUNER mode. � "TUNER" will be displayed. A few seconds later, the current radio frequency will be displayed. 2 Press TUNER (BAND) again to select the desired waveband : FM, MW or LW. 3 Press à or á for more than one second, then release. � The display will show "SEARCH" until a radio station with sufficient signal strength is found.
16

FWM55-22-GB-ENG-V01

16

v

English

CLOCK/ TIMER

MP3�CD CD1 � 2 � 3 CD

NEWS/TA

BAND TUNER

TAPE 1 � 2 TAPE

CDR/VIDEO AUX
PRESET v

A. REV

TITLE

+

VOLUME

� The PROGRAM starts flashing and "AUTO" will be displayed. � The system will start searching for all radio stations with RDS and then followed by radio stations on FM, MW and LW band respectively. � All available stations will be stored automatically. The frequency and preset number will be displayed briefly. � The system will stop searching when all the available radio stations are stored or when the memory for 40 preset radio stations is used. � The system will remain tuned to the last stored preset radio station.

Notes: � When 40 radio stations are stored and you attempt to store another radio station, the display will show "FULL�. If you want to change an existing preset number, repeat steps 3 � 5. � You can cancel manual programming by pressing � (on the system only). � During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically.

Notes: � You can cancel the automatic programming by pressing PROG or� (on the system only). � If you want to reserve a section of preset numbers, for example preset numbers 1 to 9, select preset 10 before starting automatic programming, only the preset numbers 10 to 40 will be programmed.

12/8/00, 1:57 PM

3139 115 20071