WHIRLPOOL ET22MKXRWR0
Manual de Usuario

Changing the light bulbs...
WARNING: Before removing a light bulb, either unplug the refrigerator or disconnect the electricity leading to the refrigerator at the main power supply. Shock and injury can occur electricity remains connected. if

1. Reach 2. Remove 3. Replace

behind

the control

console appliance

to find bulbs bulb.

bulb. with a 40-watt

Ice Compartment Door...
Pull the Ice compartment door bottom and slide it to the rear panel out from the

Ice cube trays...
(Model ET22MK only)
If cubes are not used, they may shrink The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get.

To remove

ice:
ends

1 Hold troy at both 2 Slightly tw:st

Automatic

ice maker.. .

l

If you have Model ET22MM and have the automatic ice maker accessory, or If you have Model ET22MK and plan to add one later (Part No ECKMF-83). there are a few things you will want to know: l The ON OFF lever IS a wire slgnal arm Down .for making Ice automatically Up. to shut off the Ice maker l Shake the bin occaslonally to keep cubes separated, and to obtain Increased storage capacity
l

You WIII hear water running when ice maker working You�ll hear ice fall into the bin Don�t these sounds bother you

IS let

l

The Ice maker ~111 not operate until the freezer IS cold enough to make ice This con take overnlght. Because Ice may of new plumbing ccnnectlons, the first be dIscolored or off-flavored Dlscard the of Ice

l

first few batches
l

If ice IS not betng made fast enough and more Ice IS needed, turn the Refrigerator Control toward a higher number Walt a day and, if necessary, turn the Freezer Control toward A If you remove the ice bin, raise the slgnal arm to shut off the Ice maker When you return the bin, push it all the way In and lower the arm to the ON posltlon If cubes are stored too long, they may develop an off-flavor like stole water. Throw them away They WIII be replaced. Cubes In the Ice bin can also become smaller by evaporation Good wafer quality IS important for good Ice quality It IS not recommended that the Ice maker be connected to a softened water supply Water softener chemicals such as salt from a malfunctioning sofiener con damage the Ice maker mold and lead to poor quality Ice If a softened water supply cannot be avoided. then It IS Important that the water softener be well molr>+alned and operatlrg properly 7

It IS normal for rce crescents corner They WIII break apart

to be attached easily On

by a
l

l

l

Arm to Start It.

Raise Signal Arm to Stop Ice Maker