|
|
|
Usuarios conectados
Actualmente hay 6043 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Quick Reference Guide
Daily check list
1. Arrange crockery so that items do not touch each other. 2. Load cups at an inclination to facilitate water circulation. 3. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards. 4. Make sure the water jet can reach all loaded items and that the spray arms rotate freely. 5. Turn on the water supply tap before starting the dishwasher.
GB Lower rack
Upper rack
Crockery holders:
� Down: cups and long-stemmed glasses. � Raised: plates.
Half load button / Multizone:
Loading the lower rack only: greater washing power, especially for plates and saucepans.
Important
� Switch off the dishwasher once the �Start� indicator lamp has switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on. If a fault occurs or you wish to change the current programme, press the �START� button for about 5 seconds until the Start indicator lamp switches off! Refer to the �Troubleshooting Guide� in these user instructions to remedy any problems.
Cutlery basket:
The cutlery basket can be removed to increase available space.
Half load button / Multizone:
If only the upper rack is to be loaded, remove the cutlery basket from the lower rack and place it in the upper one.
�
Height adjustment:
(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded. � To lower: pull out the two side handles and gently lower the rack. � To raise: pull up the two side handles until the rack clicks into place. � The rack must be level on both sides.
Plate holders:
� The plate holders may be removed to increase available space. � To remove: pull the handle up. � To reposition: simply insert in the required position (normal or crosswise).
� If a regeneration salt is to be added, IMMEDIATELY start a washing programme, in order to eliminate any residual salt.
� Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.
|
|
|
> |
|
