ELECTROLUX Z2901
Manual de Usuario

IMPORTANT SAFEGUARDS When using an electrical appliance, basic precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.

WARNING

To reduce the risk of �re, electric shock, or injury: � Do not use outdoors or on wet surfaces. � Do not leave vacuum cleaner when plugged in. Turn off the switch and unplug the electrical cord when not in use and before servicing. � Do not allow to be used as a toy. Close attention is necessary when used by or near children. � Use only as described in this manual. Use only manufacturerʼs recommended attachments. � Do not use with damaged cord or plug. If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using. � Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord around sharp edges or corners. Do not run vacuum cleaner over cord. Keep cord away from heated surfaces. � Do not use extension cords or outlets with inadequate current carrying capacity. � Turn off all controls before unplugging. � Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. � Do not handle plug or vacuum cleaner with wet hands. � Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air�ow. � This vacuum cleaner creates suction and contains a revolving brush roll. Keep hair, loose clothing, �ngers, and all parts of body away from openings and moving parts. � Do not place cleaner on furniture or stairs as the brush roll may cause damage. Place cleaner on �oor with the handle in storage position while using attachments. � Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. � Do not use without dust bag in place. � Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt. � Use extra care when cleaning on stairs. � Do not use to pick up �ammable or combustible liquids such as gasoline, or use in areas where they may be present. � Store your cleaner indoors in a cool, dry area. � Keep your work area well lighted. � Unplug electrical appliances before vacuuming them.

BEFORE YOU START
CHECK THE VOLTAGE

SAVE THESE INSTRUCTIONS
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a quali�ed plug connection as a service that can be given free of charge under the terms of the guarantee.

First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer. CONNECTING TO YOUR ELECTRICITY SUPPLY Permanently connected to the cleaner is a mains supply (2-core) cable �tted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug. If dif�culty is experienced in obtaining a replacement, contact Electrolux on 08706 055055. In no circumstances must the plug be used without a correct fuse cover �tted. If the plug that is �tted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug �tted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home.

electrician, as Electrolux cannot regard the repair of faults on the

Fuse Cover

13 Amp Fuse

Fuse

Blue

Brown Cord Clamp

2