2 Set the Power Dial to �REC�. camcorder � The Power Lamp lights and the
enters the Record/Standby mode. � When the battery packs installed in the Power Grip become weak, the case�s Power Lamp begins to blink, and the lamp goes out when the battery packs have completely discharged. Replace them with two fully charged battery packs. � Be sure to set the Power Dial to "OFF" before installing charged battery packs. � While the DC Plug is connected, even as the battery packs begin to run down, the Battery Indicator on the camcorder will show the battery packs to be fully charged .
screw 1 Align the stud onand Power Grip the direction the tripod with Power Grip�s mounting socket and stud hole. Then tighten the screw.
� Refer to the tripod's instruction manual for details on mounting onto tripod.
EN-15
