HOW TO OPERATE APPLIANCE EQUIPPED WITH SOLID STATE IGNITION IN THE EVENT OF A PROLONGED POWER FAILURE
If a powerfailureshould occur, manually light the surface burners by holding a lighted match near the surface burner and turn the surface burner on. Due to safety considerations, manual lighting of the upper Eye Level oven is NOT recommended. To manually light oven pllot: CAUTION-OVEN MUST BE COOL WHEN MANUALLY LIGHTING OVEN PILOT. If oven is warm, wait until oven cools before lighting pilot, Open broiler compartment drawer to the stop position. Place broiler tray and pan in lowest rack position. Oven pilot is located on the right side of the oven burner at the back of the oven. Hold a lighted match and reach through the broiler compartment to the oven pilot.
TRI-TEMP@
BURNER
ADJUSTMENT
The Tri-Tempo burner valve has �click� sounds to identify the HIGH, MEDIUM and WARM settings. To adjust the flame size: 1. Push in and turn surface burner knob to HIGH. For ranges equipped with Solid State Ignition, turn knob past HIGH to (START) or the light position.
(START)
2. When burner lights, turn knob to WARM.
While holding the match near the tip of the pilot, turn the Oven Temperature Control to the desired temperature. Immediately remove hand from broiler compartment. Burner will light after a 20 to 60 second delay.
3. Remove knob being careful not to change the position of the stem Grasp stem firmly and insert small blade screwdriver into the center of the gas valve stem. Turn the screwdriver in either direction until the flame height is %-inch or lower in size. Flame must be of sufficient size to maintain a STABLE FLAME OI all burner ports.
drawer. When cooking is finished, turn the Oven Temperature Control to OFF. This will shut off all gas to the oven. Whenever electrical power is off, you will have to light the pilot manually each time you wish to use the oven. CAUTION: IF THE OVEN BURNER DOES NOT LIGHT WITHIN 20 TO 60 SECONDS AFTER THE PILOT IS LIGHTED, TURN THE OVEN TEMPERATURE CONTROL TO OFF AND WAIT FOR POWER TO BE RESTORED. DO NOT ATTEMPT TO RELIGHT THE PILOT AGAIN. If oven does not function properly when the power is restored, call a serviceman to determine the problem.