FOCUSRITE SAFFIRELE
Manual de Usuario

Troubleshooting
LEDs on the Saffire LE hardware aren�t working � Does the unit have power? This is supplied by the Firewire cable, is one connected? If connecting to a 4-pin Firewire port, is the external PSU connected? Saffire LE is not recognised as a valid audio interface by the recording software in use (e.g. Ableton) � Is the hardware connected to the computer over Firewire? � If using a PC, have the ASIO/WDM drivers been correctly installed from the accompanying DVD? No signal when using mic inputs � Is the unit powered correctly? See above. � Is the gain dial of the corresponding input on the hardware set sufficiently high? Rotate clockwise to increase the level. � Is something connected to the corresponding line input on the hardware? This will deactivate the mic input. � For microphones that require phantom power (e.g. condenser mics), is the +48V switch on the front panel engaged? (If you are unsure about whether your microphone requires phantom power, check the user guide for your microphone.) � If seeing but not hearing a level, is the slider for the monitoring pair of outputs far enough to the left (towards the INPUT MIX position)? If over to the right (in the P/BACK position), only the tracks from the sequencer will be heard. No signal when using line inputs 1 and 2 � Is the unit powered correctly? See above. � Is the gain dial of the corresponding input on the hardware set sufficiently high? Rotate clockwise to increase the level. � Is the Line/Inst switch on the hardware set correctly? The LINE LED must be active. � If seeing but not hearing a level, is the slider for the monitoring pair of outputs far enough to the left (towards the INPUT MIX position)? If over to the right (in the P/BACK position), only the tracks from the sequencer will be heard. No signal when plugging an instrument into line inputs 1 and 2 � Is the unit powered correctly? See above. � Is the gain dial of the corresponding input on the hardware set sufficiently high? Rotate clockwise to increase the level. � Is the Line/Inst switch on the hardware set correctly? The INST LED must be active. � If seeing but not hearing a level, is the slider for the monitoring pair of outputs far enough to the left (towards the INPUT MIX position)? If over to the right (in the P/BACK position), only the tracks from the sequencer will be heard. No signal when using Line Inputs 3 and 4 � Is the level on the sending device or instrument high enough? � If using an Instrument (Guitar or Bass plugged in directly), is the corresponding High Gain switch on the left of the SaffireControl GUI active? � If seeing but not hearing a level, is the slider for the monitoring pair of outputs far enough to the left (towards the INPUT MIX position)? If over to the right (in the P/BACK position), only the tracks from the sequencer will be heard.