KENWOOD KTF-2010
Manual de Usuario

Storing broadcast stations in memory
KTF-3010/KTF-2010 (En)

10
The automatic memory function allows you to store up to 40 stations using only one button. The manual preset function allows you to store stations one at a time. Use the automatic memory function first.

The figure shows an example for the KTF-3010
AM-FM STEREO SYNTHESIZER TUNER KTF-3010 HIGHBLEND WIDE ACTIVE RECEPTION TA/NEWS NARROW PTY/ PTY SCARCH IF BAND DISPLAY RF ATT ANT A/B MEMORY RFATT
EON RDS

TUNING/MULTI CONTROL

BAND

TUNING MODE +10/CLEAR

P. CALL DOWN UP

ON/STANDBY 1

2

3

4

5

6

7

8

9

0/CHARA.

: Keys or controls to be used in this operation.

AUTO MEMORY (Storing stations automatically in memory )
The AUTO MEMORY function automatically calls up only those stations which have RDS broadcasts for storing (up to 40 stations can be stored).
1 Switch to FM band. 2 Press and hold the MEMORY key (for more than 2 seconds).
MEMORY

The tuner completes the scanning of frequencies in 5 minutes. While scanning, "AUTO" and "MEMORY" are displayed in turn. ÷ Unless stations are stored with the automatic memory function, EON

reservation and PTY search will not work. ÷ AR will not work when the automatic memory function is on. ÷ Broadcast stations stored manually may be overwritten. ÷ Stations already stored in the preset memory may be replaced by RDS stations. (i.e., If the RDS AUTO MEMORY function finds 15 RDS stations, the stations currently preset at numbers 01- 15 are replaced by the RDS stations.) ÷ If the antenna is replaced, you will have to reset the automatic memory function. ÷ Stored stations may be erased from the memory.

MANUAL PRESET(Storing stations one at a time) 1 Tune in the station to be preset 2 Press the MEMORY key
Perform the operations in the five seconds that the display is blinking.
MEMORY
STANDBY
AR

Lights (for 5 sec.)
MEMO ANT A B STEREO TUNED AUTO kHz MHz

AM FM

01
Blinks

89 ))
Lights (for 5 sec.)
MEMO ANT A

If you press the MEMORY key when the preset number displayed is "- -", the smallest unstored number appears.

(If more than 5 sec. have elapsed, press the MEMORY key again.)

3 Select one of the preset numbers from 1 to 40.
1 Turn the TUNING/MULTI CONTROL knob.
TUNING/MULTI CONTROL

AR

15
FM
UP

9 ). ) )
38, 39, 40

STEREO TUNED AUTO MHz

The numbers 1 to 40 appear, in turn, as you turn the knob.
DOWN

01, 02, 03

2 Select the desired station.
MEMORY

Instead of steps 1 and 2, you can use the numeric keys (0~9,+10), to store the broadcast stations. Press the numeric keys (0 to 9, +10) in the following order. To select �15�...0,5 To select �20�...0,0, )

÷ Repeat steps 1 to 3 for each of the stations to be stored in memory. ÷ If a station is stored in a preset number which already stores a station memory under it, the previous memory is replaced by the new memory content. ÷ Once the memory content has been preset, it is held for about 3 days even after the power cord is unplugged from the mains outlet. ÷ You cannot enter numbers over 40. ÷ If you make a mistake when pressing the 0 key, press the 0 key several times to return to the original display before re-entering. ÷ The stored station will be erased from the memory.