1. Remove the dust cover and switch cover to expose the electrical connections of the power cord, ON/OFF switch, and wire cord.
4. Install the belt, agitator assembly, and the lower plate according to the respective instructions.
2. Pull the power cord into the dust compartment in order to remove the strain relief by prying or cutting, remove the wire connectors, and wire tie, if present.
3. Pull the power cord out of the dust compartment for power cord replacement.
3.5.2.
Installation
1. Insert the new power cord into the dust compartment as far as necessary in order to place a new cord retainer in proper location on power cord. The proper location is approximately one and one eighth inches/thirty millimeters (1 1/8�/30 mm) of new power cord outer jacket extending past the cord retainer and washer. The washer goes between the cord retainer and the dust compartment. Attach wires with wire connectors according to the wiring diagram in the front of this manual. ONLY USE A NEW CORD RETAINER, DO NOT REUSE A CORD RETAINER. 12
