DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF MECHANICAL PARTS AND P.C. BOARDS
1-1: TOP CABINET AND FRONT CABINET (Refer to Fig. 1-1) 1. 2. 3. 4. 5. 6. 7. Remove the 5 screws 1. Remove the Top Cabinet in the direction of arrow (A). Disconnect the following connector: (CP651). Unlock the 8 supports 2. Remove the Front Cabinet in the direction of arrow (B). Remove the 2 screws 3. Remove the Operation PCB in the direction of arrow (C).
Top Cabinet
1-3: DVD DECK (Refer to Fig. 1-3) 1. Make the short circuit on the position as shown Fig. 1-3 using a soldering. If you remove the DVD Deck with no soldering, the Laser may be damaged. 2. Unlock the support 1 and remove the Deck Top Holder in the direction of arrow (A). 3. Remove the 2 screws 2. 4. Remove the screw 3. 5. Remove the screw 4. 6. Disconnect the following connectors: (CP2601, CP2602, CP2603). 7. Remove the DVD Deck in the direction of arrow (B). 8. Remove the 3 screws 5. 9. Remove the Front Angle in the direction of arrow (C). 10. Remove the screw 6. 11. Remove the DVD Angle.
DVD Deck Deck Top Holder
1 1
1 1
4 3
Pick Up PCB
2
(A)
1
Front Cabinet
1 2
(B)
2 2
2
3 2 2
(A)
3
CP651 Operation PCB
(B)
Make the sort circuit using a soldering. DVD Angle
2 2
(C)
2
5
Fig. 1-1 1-2: FLAP (Refer to Fig. 1-2) 1. Open Flap to 90� and flex in direction of arrow (A), at the same time slide in direction of arrow (B). 2. Then lift in direction of arrow (C). NOTE
5
5
(C) CP2601 CP2603 CP2602
6
Front Angle
Fig. 1-3
(A)
When the installation of the DVD Deck, remove all the soldering on the short circuit position after the connection of Pick Up PCB and DVD PCB connector.