Attaching the GK-3 to the Guitar 4) After removing the pickup, carefully remove the double�sided tape from the bottom of the pickup. Adjust the height of the Pickup. If you wish to add a spacer, first completely remove the used double� sided tape from the top surface of the existing spacers, then add the new spacer. If you need to remove any spacers, remove the necessary number of spacers and completely remove the remaining double�sided tape from the top surface. 6) Attach two pieces of the new double�sided tape B to the bottom of the pickup. 7) 8) Attach the pickup to the top of the spacer that is applied to the guitar side. Restring and tune the guitar, then check the height of the Divided Pickup again.
5)
*
Afterwards, you will need to adjust the pickup sensitivity when connecting to GK devices. However, you may find that the sensitivity level on the GK device is too high. In such instances, you may be able to correct the problem by widening the clearance between the strings and the pickup. Carry out Steps 1 through 8 again to lower the Pickup height slightly.
How to Use the Clearance Gauge
The divided pickup height must be adjusted so that the clearance between each string and the divided pickup is 1.0 mm (0.04�) when the highest fret is fingered. The clearance gauge supplied with the GK-3 is 1.0 mm thick; place the gauge between the strings and the divided pickup as shown in the figure below, then check and adjust the height.
fig.1090 (Clearance Gauge)
