12. Unhook the pick-up stay spring [I]. 13. Remove the front and rear screws securing the feed roller housing [J] (3 screws). 14. Remove the housing stay [K] and the pick-up stay cover [L] (2 screws). 15. Remove the E-ring and bushing from the front of the tray feed shaft [M]. 16. Slide the tray feed roller shaft to the rear until it clears the front frame, and then slide off the front feed roller housing [N]. 17. Remove the tray feed roller [O] by sliding the pick-up stay [P] to the front (1 E-ring and 1 bushing). NOTE: a) As the tray feed roller has a one-way clutch, it is important to mount the roller correctly. The pick-up roller drive belt should be towards the front. b) When replacing the cassette feed clutch bracket, secure it with the three screws, then slide the pick-up gear slightly to the front and align the sector gear and the pick-up gear as shown in the figure. (The marked tooth on the sector gear fits in between the marked teeth of the pick-up gear.)