Note: Enclosure sheet 1 is attached to comply with the safety standards. Make sure that it will not be shifted or peeled off. If it is peeled off, securely reattach it in its original place.
2 3 4
B
Remove the jumper wire by removing the flat clamp. Remove the one nyron rivet. Remove the one screw.
6 2
Flat clamp
Front chassis VR (43M)
6 4
1
3 5
Note: Be sure to remove this screw. If you don't, the connector on the LED OPT Assy may be damaged.
Enclosure sheet 1
LED OPT Assy
5 6
Remove the LED OPT Assy. Remove the front chassis VR (43M) by removing the five screws.
7 8 9
C
Remove the seven screws. Remove the two spacers. Remove the X CONNECTOR A and B Assy.
43 X DRIVE Assy
7 8
�3
7
�4
8 9
X CONNECTOR B Assy
Note when reassembling the front chassis VR (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.
9
X CONNECTOR A Assy
43 SCAN A and B Assy
D
1 2 3 4
Remove the one nylon rivet. Remove the jumper wire by removing the flat clamp. Remove the one screw. Remove the front chassis VL (43M) by removing the five screws.
4
4
43 Y DRIVE Assy
4
4
Front chassis VL (43M)
Flat clamp
4 2
3
1
E
5 6 7 8
Remove the four screws. Disconnect the two pin connectors. Remove the six spacers.
43 Y DRIVE Assy
65 7 7 8
55 7 7
56 7 8 7
Remove the 43 SCAN A and B Assy.
Note when reassembling the front chassis VL (43M) Remove or loosen the screws that secure the panel holder in order not to damage the front protect panel Assy.
F
