1. Slide the chassis completely out of the guide rails. 2. Stand the receiver on its edge. The underside of the board is completely accessible for component replacement.
Note: Some tie-wraps that secure the wire dressings may need to be unfastened for chassis removal.
C-Board - CRT output The board plugs onto the socket on the CRT neck. To release the Focus wire, use a dull object to release the tab on the socket (near the wire opening) and carefully pull on the wire. To connect the focus wire, press on the tab to lock it then insertthe wire in the opening and press on it until it is fully inserted and locked in place. Focus cable release
Speakers Each speaker is secured to the cabinet with 4 screws. NOTE When reassembling speakers be sure to connect the speaker wires to the correct speaker lead (+) (-)
9.1. Disassembly for CRT replacement 1. Discharge the CRT as instructed in the �safety precautions�. 2. Disconnect the yoke (DY) plug, degaussing coil (DEG) plug from the main board.
