WHIRLPOOL CNG2010AAW
Manual de Usuario

�

SAFETY PRECAUTIONS
HOW TO LIGHT CONSTANT STANDING PILOTS (This information is NOT for ranges equipped with Pilotless Ignition). Be sure Oven Temperature Control and Surface Burner Controls are OFF before _ _,_ HOW TO ADJUST CONSTANT STANDING PILOTS FOR SURFACE BURNERS ONLY 1. Remove cooktop. Locate top burner and pilot adjusting screw. (a) Adjusting screw is to the LEFT

Surface pilots. lighting Burner Pilots: Raise and support on the _ cooktop metal rod. Holda lighted match near the

MANIFOLD°ftheovenc°ntr°lonthepIPE. 2_ Insert a small screwdriver into the adjusting screw and turn screw to the right or left until the flame on the pilot is _A-inch in height. 3. Replace cooktop.

= "-

ILL

_

Oven Pilot: Remove oven racks and loosen screws securing insulated oven bottom. Do not remove screws, but slide screws back and remove oven bottom. With the Oven Control knob/dial set in the "OFF" position, hold lighted match to the pilot located at the far end of the oven burner. When pilot is lighted, replace the oven bottom and oven racks. Be sure to secure the two screws located at the front of the oven bottom.

_

_

j,° � o*

,<, 7

.
7