WHIRLPOOL CGR3510ADH
Manual de Usuario

SURFACE COOKING
Yourrange is equippedwith pilotless ignition.Be sure all surface controls are set in the OFF position prior to supplyinggas to the appliance, IMPORTANT:When the appliance is first installed,the surfaceburnersmay be difficult lightdueto air in the to gasline.This mayalso occuriftheappliancehas been disconnected fromthe maingassupplyorif ithas not beenusedfor severaldaysor weeks, Toremovethe airin thegas line,hold a lightedmatch nexttothe burnerheadandturnthe knobon. When the burnerlights,eitheradjustthe knobto the desired flame size or turn the burner off. To prevent damageto the cooktopor pan, never operate surface burner withouta pan in place, never allow a pan to boil dry and neveroperate a surface burner on HIGH for extended periods of time. To light surface burner: 1. Place a pan onthe burnergrate. NOTE:The burnerflame may liftoffthe burnerhead and a !'roaring" oundmay be heardifa pan isnot s placedonthe grate beforelighting burner. the 2. Push in andturnknobto the LITE position.

burner.There are two ignitorsfor conventionalsurface burners. Each sealed burner has its own ignitor,Once the burner lights,turn the knob to the desired setting. The Pilotlessignitionuses a spark from the ignitor to light the clicking sound will not stop until the knob is turned from the LITE position.

l

_

t

When one burneriSturnedon, all ignitors willsparki 3. After the burnerlights,turn the knob tothe desired flame size. The ignitors willcontinue sparkuntilthe to A knob isturnedfromthe LITE position. clickingsoundwill be heardand the burnerwill:light, CAUTION: If the flameshouldgoout duringa cooking operation_ turn the burner off. If gas has accumulated and a strong gas odor is detected, wait 5 minutesfor the gas odor to disappear before relighting burner. To light surface burner during a power failure: 1. Be sureall controls in the OFF position. are 2. Holda lightedmatchto the desiredsurface burner head. 3. Push inand turn knobto the LITEposition. he burner T willthen light. 4. Adjusttheflameto the desiredflame size, CAUTION: When lightingthe surface burner,be sure all of the controls are in the OFF position.Strike the matchfirst and hold it in position beforeturning the knob to the LITE position.

Ignitor

NOTE: The surface burner will not light if the ignitor is damaged,broken, soiledor wet. Also, the burner will not light if the small port beneaththe ignitor is blocked. See page23 for cleaninginstructions.