TEAC CD-01UPRO
Manual de Usuario

1 - Introduction � Environmental considerations
Rack-mounting the unit
Use the rack-mounting kit to mount the unit in a standard 19-inch equipment rack, as shown below. Remove the feet of the unit before mounting. If you are mounting the unit in a rack, leave 1U of space above it and 10cm (4 in) or more of space at the rear. The CD-01U/CD-01U Pro can be mounted in any angle between 0 to 90 degrees. SeeEnvironmental considerationson the previous page.

Handling of compact discs
The CD-01U/CD-01U Pro have been designed for the playback of CD-DA format discs and MP3 files recorded in ISO9660 format. In addition to ordinary 5-inch and 3-inch CDs, it can also play properly recorded CD-R and CD-RW discs. When removing a CD from its case, press down on the center of the disc holder to free the CD, then lift the disc out, holding it carefully by the edges. � Removing a disc � Keep discs away from direct sunlight, and places of high heat and humidity. If left in such places, warping could result. � Do not affix any labels or stickers to the label side of the disc. Do not write on the disc with a ballpoint pen. � Please do not insert discs that have adhesive remaining from tape or stickers that have been removed. If they are inserted into the player, they could stick to the internal mechanism, requiring removal by a technician.

� Hold the CD like this � Only use circular compact discs. Avoid using non-cir cular promotional, etc. discs. � The CD-01U/CD-01U Pro cannot play unfinalized CD-R/RW discs. � Avoid getting fingerprints on the signal side (opposite the label side). When cleaning, wipe gently with a soft cloth from the center towards the outside edge. Dust and grime may cause skipping, so keep discs clean and store them in their cases when not being played. � Do not use a C-thru disc. The unit does not support a C-thru disc. Therefore, you may not be able to insert a C-thru disc or may not be able to remove a C-thru disc that has been successfully inserted to the unit. In the latter case, try to press the DISPLAY and EJECT keys simultaneously, which may solve the problem. � Do not use the DualDisc. DualDisc is two-sided playback only discs. Insertion or ejection of a DualDisc into/from CD-01U/CD-01U Pro is likely to cause scratches to the surface of the DualDisc. Scratched discs may not play in CD products. A DualDisc may not play in CD-01U/CD-01U Pro and a DualDisc could get stuck in and may not be able to be removed from the CD-01U/CD-01U Pro.

� Do not use any record spray, anti-static solutions, benzene, paint thinner or other chemical agents to clean CDs as they could damage the delicate playing surface. � Discs should be returned to their cases after use to avoid serious scratches that could cause the laser pickup to skip.

TASCAM CD-01U/CD-01UPro

7