SHARP AR151E
Manual de Servicio

AR-151E

[4] USER PROGRAM
The conditions of factory setting can be changed according to the use conditions.

Functions which can be set with the user program
Function Auto clear time Contents
q When a certain time is passed after completion of copying, this function returns to the initial state

Factory setting 60 sec

automatically. The time to reach the initial state can be set in the range of 30 sec to 120 sec by the unit of 30 sec. This function can be disabled.
q When the copier is left unused with the power ON, the power consumption is automatically reduced

Preheat

to about 40Wh/H (� Note). The time to start this function can be set in the range of 30 sec to 90 sec by the unit of 30 sec. This function cannot be disabled.
q When this function is operated, the pre-heat lamp on the operation panel lights up.

90 sec

To return to the initial state, press any key on the operation panel. (When the COPY button is pressed, a copy is made after returning to the initial state.)
q When the copier is left unused with the power ON, the power consumption is automatically reduced

Auto shut off timer

to about 18Wh/H (� Note). The time to start this function can be set in the range of 2 min to 120 min.
q When this function is operated, all the lamps except for the pre-heat lamp on the operation panel

5 min

turn off. To return to the initial state, press the COPY button. Stream feeding Auto shut off Only models with SPF.
q Used to set or cancel this function.

Cancel Set

�Note: The power consumption values in preheat and auto shut off may be varied depending on the use conditions.

Setting the power save modes, auto clear time, and stream feeding mode
1) Press and hold down the light ( ) and dark ( ) keys simultaneously for more than 5 seconds until all the alarm indicators ( , , and ) blink and "- -" appears in the display. 2) Use the left copy quantity ( ) key to select a user program number (1: auto clear time, 2: preheat mode, 3: auto power shut-off timer, 4: stream feeding mode, 5: auto power shut-off mode). The selected number will blink in the left side of the display.

Function name Auto clear time Preheat Auto shut off timer Stream feeding Auto shut off correct function code. � SPF only

Function code 1 2 3 4V 5

[Cancel] If a wrong code is entered, press the clear key and enter the

� The remaining toner quantity is displayed by pressing the % key for 5 sec before entering a program code in the user simulation mode. 3) Press the print ( ) key. The entered program number will be steadily lit and the currently selected parameter number for the program will blink on the right side of the display. 4) Select the desired parameter using the right copy quantity ( ) key. The entered parameter number will blink on the right of the display. Function name Set code 0 (Cancel) Auto clear time 1 (30 sec) �2 (60 sec) 3 (90 sec) 4 (120 sec) 5 (10 sec) Preheat Function name Set code 0 (30 sec) 1 (60 sec) �2 (90 sec) Auto shut off timer Function name Set code 0 (2 min) �1 (5 min) 2 (15 min) 3 (30 min) 4 (60 min) 5 (120 min) Stream feeding Function name Set code �0 (Cancel) 1 (Setting) Auto shut off Function name Set code 0 (Cancel) �1 (Setting)

� : Factory setting 5) Press the print ( ) key. The right-hand number in the display will be steadily lit and the entered value will be stored. Note: To change the setting or to set another mode, press the clear ( ) key. The copier will return to step 2). 6) Press the light ( ) or dark ( ) key to return to the normal copy mode.

4�1