2 The screen for revising IN/OUT points appears in P
IN (P OUT) � R IN (R OUT) � OFF order.
1 Press the PLAY button in the play list screen to
display video.
2 Press the IN (OUT) + GOTO buttons or operation
buttons and press the IN (OUT) + ENTRY buttons where the revision will be made to reregister.
You can perform fine adjustment (trimming) by hold down the IN (OUT) button and pressing the TRIM (+/�) button.
Revising in the Play List Screen
3 Press the TRIM+/� button to trim.
� NOTE:
� The RESET button clears registered points. � Holding down the button enables fast-forwarding.
1 Hold down the SHIFT button in the play list screen
and press the IN (OUT) button.
4 Press the ENTRY button to finalize the change.
Or press the SET button to finalize.
Previewing and Adjusting Sound Volume
Use the following steps to preview overwritten area (in orange) to check audio and video.
2 Use the playback volume to adjust playback level
during preview.
� The playback level is fixed at the level set during preview. � Review and play list playback plays back events at the imported sound volume.
1 Hold down the SHIFT button and press the PLAY
button
Playback starts 3 seconds prior to the overwritten area and 1 second after the area.
� NOTE: � NOTE:
� Press the STOP button to stop previewing. � Overwrite edited events in unfinalized status (all events if more than one) are played back regardless of pointer location. � The sound can be adjusted only during a preview. � When there are multiple events, all events are played back at the same sound volume. � The same sound volume is used in an event and cannot be changed.
Finalizing Overwrite Editing
Use the steps below to finalize overwrite edited events in unfinalized status and return to normal event operation.
button) to clear all IN and OUT points. � Exiting the play list by pressing the PLAYLIST button clears all unfinalized events and all IN and OUT points. � Use the following steps to change channel settings after finalizing an event. 1. Select an event or multiple events to edit. 2. Choose [SETTING] � [AUDIO CH] from the menu to change the channel setting. 3. Choose [OPERATION] � [EDIT AUDIO CH] from the menu. 4. Select YES. The recalling method can also be used.
1 When there are any unfinalized events, press the
REC button.
2 This finalizes the event and changes the orange of
the unfinalized event to white. � NOTE:
� When an event is not to be registered, clear the IN or OUT point or use CANCEL (hold down the SHIFT button and press the EXIT
