ASSEMBLY
Fitting the handlebar (232R) Fitting the handlebar (235R, 235FR)
� �
Remove the screw at the rear of the throttle handle. Slide the throttle handle onto the right side of the handlebar, (see diagram).
� �
Remove the screw at the rear of the throttle handle. Slide the throttle handle onto the right side of the handlebar, (see diagram).
� � � �
Align the screw hole in the throttle handle with the hole in the handlebar. Re�t the screw in the hole in the rear of the throttle handle. Screw the screw through the handle and handlebar. Tighten it. Unscrew the knob from the handlebar mounting.
� � � � �
Align the screw hole in the throttle handle with the hole in the handlebar. Re�t the screw in the hole in the rear of the throttle handle. Screw the screw through the handle and handlebar. Tighten it. Remove the mounting components from the handlebar mounting. Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.
�
Position the handlebar as shown. Fit the mounting components and tighten the knob lightly.
�
Fit the wiring as shown.
�
Put on the harness and hang the machine from the support hook. Now make a �nal adjustment so that the machine is in a comfortable working position when it hangs from the harness. Tighten the knob.
�
Put on the harness and hang the machine from the support hook. Now make a �nal adjustment so that the machine is in a comfortable working position when it hangs from the harness. Tighten the knob.