Once the top of the panel has been correctly positioned, �x it through the holes in the bottom bracket, without tightening the screws (Fig. 10). Fig. 10
Once the door has ben correctly aligned, tighten the holding nuts on the �xing brackets and attach the appliance to the adjacent units and the bottom of the work surface (Fig. 12). Fig. 12
D471
Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the �xings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket. Fig. 11
D
If the appliance has been �tted into a space 820 mm high and the maximum height of the base plate is 100 mm, �t the front cover plate by pushing the two vertical lugs into the rectangular holes on the bottom side of the ventilation duct until they click. The plate can be adjusted backwards or forwards in the holes (Fig. 13). Fig. 13
820 870
