ZANUSSI ZK23/11EDS
Manual de Usuario

Installation
Positioning
� Place the refrigerator away from direct sunlight and heat sources. � Maintain recommended ventilation - see Fig. 1. � Make sure the refrigerator is accurately levelled turning the adjustable feet in order to avoid vibrations and noises, Fig. 2. � This is a built in design to be aligned with other furniture

Cleaning the interior

� Do not use alcohol or any cleanig product containing alcohol because it can damage the cabinet. � Before using the appliance for the first time wash the interior whith luke warm water and some neutral soap so as to remove the typical smell of a brand-new product arid then dry thoroughly. � Do not use detergents or abrasive powders as these will damage the finish. � Remove security used for transportation.

Fig. 1

Electrical connection

m Before plugging the appliance make sure that the voltage and frequency shown on the «Technical Features» correspond to your home supply. It is essential that the appliance be efficiently earthed. m For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not grounded, have the appliance connected to a separate ground wire in accordance with existing safety regulations. «THE MANUFACTURER DECLINES TO ACCEPT ANY LIABILITY IF THIS SAFETY RULE IS NOT OBSERVED». Should a change of the suplly cord be necessary, remove the lid of the terminal board acting on «E» and «F» as shown figure 3 in order to gain access to the terminals. Fig. 3.

Fig. 2

Starting � up

� Plug the appliance into the mains. � Make sure the inner light turns on when opening the door. � Turn to intermediate position the knobs of the «temperature regulators»: «A» for refrigerating compartment and «B» for freezing compartment.

Fig. 3
17