AEG ZHC925
Manual de Usuario

Fitting the Canopy Hood
Before starting to fix the canopy it will be necessary to adjust the support brackets S1 by turning the screws clockwise until the limit of the thread is reached as illustrated in Fig. 8. aHook the canopy onto the two 4.2x44.4mm screws1 fitted as described above and illustraed in Fig. 9. Using a screw driver and spirit level, adjust the screws S1 until the canopy is level. Once the canopy is level, tighten up the wall fixing screws to secure the canopy.

S1

S1

b-

Electrical connection and working test Before fitting the chimney to the canopy make the electrical connection as described in the section titled �ELECTRICAL CONNECTION�. When the electrical connection has been made, test the three speed fan and worktop illumination.

Fig. 8
1 1 1

Venting
The hood is more effective when used in the extraction mode (ducted to the outside). Venting kits may be purchased through your retailer or DIY store, and must be ducted to an outside vent of 125mm (5�). The ducting used must be manufactured from fire retardent material conforming to the relevant British Standard or DIN 4102-B1. When the cooker hood is ducted to the outside the charcoal filter must be removed.

Fig. 9
P1 P1

Recirculation
The cooker hood is supplied specified for use in the recirculation mode, with the charcoal filters fitted. In the recirculation mode contaminated air is passed through the charcoal filters to be purified and recirculated into the kitchen through the grille outlets on either side of the chimney (G). To assemble the recirculation duct, place the �push-fit�recirculation extension pipe P over the spigot on the top of the canopy; place the �push-fit� spigot R on to the pipe P and insert the extension pieces P1 into either side of the spigot as illustrated in Fig. 10.

R P I G

Fig. 10
14