ZANUSSI ZHC590X/GB
Manual de Usuario

INSTALLING THE COOKER HOOD
Chimney Stack
The chimney consists of two sections. The lower chimney measures (with the Hood body and recirculation grilles) 935 mm and the upper chimney measures 290 mm. The overall installed measurement is min. 935 - max 1215 mm.

Fitting the Upper Chimney and the Hood Body
� Position the upper chimney stack and �x the top of it to the frame using 2 of the screws removed as above. � Open the lighting unit by pulling on the notch, disconnect it from the hood canopy by sliding out the �xing pin. � Remove the activated charcoal �lters, if �tted. � In order to �x the hood body to the frame insert the 4 screws 12f in their seats. It is necessary to leave at least 4-5 mm gap between the screw heads and the frame plate. � Hook the hood canopy to the frame and turn it to the left until it reaches the stop, then lock the screws immediately to prevent the hood canopy from falling out accidentally. � Make sure that the outlet of the extension piece 14.1 is horizontally and vertically aligned with the chimney outlet. � If this is not the case, remove the lower Chimney Stack and adjust the position of Extension 14; replace the elements as described above. � Insert Connector Extension 14.1 sideways into Extension 14.2. � Fit the directional grill 8 into the housing provided. Also make sure that it is properly �tted into connector 14.1.

14.1

1
2

Electrical Connection
� Ensure that the supply cable connector is properly inserted into the Suction device socket � Hook up the Commands connector Cmd. � Hook up the Spotlights connector Lux to the socket provided behind the lighting unit cover. � For the recirculation version, �t the activated carbon odour �lter. � Replace the grease �lters. � Replace the lighting unit.

Lux

Cmd

18