AEG ZDC 5375 W
Manual de Usuario

Operating Sequence
Before using your tumble dryer for the first time, we recommend to place a few damp cloths inside the appliance and dry for 30 minutes. There may be dust inside a brand new tumble dryer. Example: Press the «Change» button until the desired language appears in the display.

Drying
1. Connect the appliance. 2. Open the door (see picture).

Language ENGLISH
Temp. Spin Options Change

Sprache DEUTCH
Exit
Temp. Spin Options Change

Exit

A

Press the EXIT button to confirm the selection.

Einstellungen

P1149

P1108

Temp.

Spin

Options

Change

Exit

3. Load the items one at a time, shaking them out loosely. 4. Close the door. Please check the laundry does not get caught between the door and filter. 5. Turn the selector dial to the desired programme to switch the appliance on. To switch the appliance off turn it to «Reset/Off».
Reset/ Memory 2 Memory 1 Cooling 30 min 60 min Baby Iron dry Store dry Off Cotton extra dry Ready to wear Store dry Slightly damp Iron dry Machine iron dry Synthetic extra dry

B

All indicators on the display will appear in this language from now on. Note: If the undesired language has been set, press the «Spin and Option» buttons simultaneously for about 3 seconds in order to change the language. Follow the instructions as before. Setting the time You should set the time prior to the first drying cycle and when changing to and from daylight savings time. See «Clock setting», Menu. 6. Turn the selector dial, in order to select the desired programme. The relevant message will appear in the display. The display will show the end cycle time «Cycle end at» of the selected programme, calculated on the basis of the maximum load for each type of fabric. The START/PAUSE button light will start flashing. If the load of laundry to be dried is small, at the beginning of the cycle the display will still indicate the end cycle relevant to the maximum load.

Switching on the appliance for the first time. Language When switching on the appliance for the first time you must set the language in which you want the indicators on the display to appear. Important! If the display is not showing any language, the appliance has already been switched on once. In such case, go to the chapter «Change language» if you would like to change the language setting.

12