9. Drive motor disassembly
1 Remove the document table. 2 Remove the top cabinet. 3 Remove the bottom cabinet and remove the drum cartridge. 4 Remove the motor encoder sensor PWB and the encoder. 5 Remove the main chassis and remove the drive unit. 6 Remove the drive motor. (2 screws)
11. Lower heat roller disassembly
1 Remove the document table. 2 Remove the top cabinet. 3 Remove the bottom cabinet and the drum cartridge. 4 Remove the main chassis. 5 Remove the lower heat roller.
12. Heater lamp disassembly
1 Remove the document table and the top cabinet.
10. Power PWB disassembly
1 Remove the document table. 2 Remove top cabinet. 3 Remove the bottom cabenit and the drum cartridge. 4 Remove the main chassis. 5 Disconnect the connectors and the grounding cable (1 screw). 6 Remove the three fixing screws and remove the power PWB.
2 Remove the screw which secures the heater lamp terminal in the
rear side, and remove the heater lamp terminal.
3 Pull out the heater lamp from the rear side.
Note: Do not touch the glass surface of the heater lamp directly with your hand.
@
Note for assembly: When assembling, put the rating indication (e.g., 100V 600W) of the heater lamp towards the front side.
