ELECTROLUX Z2010
Manual de Usuario

English
REPLACING THE S-BAG�/CLEANING THE FILTER

1 The dust bag, s-bag� must be replaced when the indicator window is completely red. Read the indicator with the floor nozzle lifted up from the carpet. 2 Remove the hose and open the lid. 3 Pull the cardboard holder to remove the s-bag�. This automatically closes the dust bag and stops dust from leaking out. 4 Insert a new s-bag� by pushing the cardboard holder straight down in its tracks. Close the lid.

1

2

3

Note: Replace the s-bag� even if it is not full (it may be blocked). Also replace after using carpet-cleaning powder. Use only Electrolux original dust bags � s-bag� Classic, s-bag� Clinic or s-bag� Anti-odour.
Replacing the motor filter (Ref. No. EF54)

Should be done with every 5th replacement of the dust bag, s-bag�
5 Depress the catch and open the lid. 6 Remove the old filter 7 Insert a new filter and close the lid. Replacement of exhaust filter or non-washable HEPA filter

Should be done with every 5th replacement of the dust bag, s-bag�
There are two types of exhaust filter, depending on the vacuum cleaner model: � Hepa H12 (Ref. No. EFH12) � Microfilter (Ref. No. EF17) The filters must always be replaced with new ones and cannot be washed. 8 Open and remove the lid, remove the filter (every fifth bag change). 9 Insert a new filter and replace the lid as shown in the picture. 4 5 6 +7 Cleaning the washable 02 HEPA filter (ref. no. EFH13W, some models only)

Should be done with every 5th replacement of the dust bag, s-bag�
10 Open and remove the lid, then remove the filter. 11 Rinse the inside (dirty side) of the filter in warm tap water. Tap the filter frame to remove excess water. Repeat four times and allow the filter to dry. Note: Do not use cleaning agents and avoid touching the delicate filter surface. 12 Replace the filter and lid as shown.

8 + 10

9 + 12

11

10