WHIRLPOOL YACQ209MR0
Manual de Usuario

2. Press the plus or minus button to adjust the delay time (1 to 24 hours). 3. Press TIMER again or wait 10 seconds. Timer indicator light will remain on. Hour indicator light will turn off, and Room indicator light will turn on. Display will show the current room temperature.

To operate air conditioner with remote control
NOTE: Remote control may vary in appearance.

To set the Timer to turn on the air conditioner, keeping previous settings:
1. Turn off air conditioner. 2. Press TIMER. Timer indicator light will flash. Hour indicator light will turn on, and display will show remaining hours before air conditioner will turn on. 3. Press the plus or minus button to change delay time (1 to 24 hours). 4. Press TIMER again or wait 10 seconds. Timer indicator light will remain on. Hour indicator light will turn off, and Room indicator light will turn on. Display will show current room temperature.

To set the Timer to turn on the air conditioner, changing the previous settings:
1. Turn on air conditioner. 2. Adjust Mode to Auto, Cool, Fan Only, or Power Saver. NOTE: For Auto mode, go to Step 4. 3. For Cool, Fan Only or Power Saver mode, adjust FAN SPEED to Turbo, High or Low. 4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC). 5. Wait 3 seconds before turning off air conditioner. 6. Press TIMER. Timer indicator light will flash. Hour indicator light will turn on, and display will show remaining hours before air conditioner will turn on. 7. Press the plus or minus button to change delay time (1 to 24 hours). 8. Press TIMER again or wait 10 seconds. Timer indicator light will remain on. Hour indicator light will turn off, and Room indicator light will turn on. Display will show current room temperature.

NOTE: Two AA batteries (not included) power the remote control. Replace batteries after 6 months of use, or when the remote control starts to lose power.

To turn the air conditioner on or off:
Press POWER.

To clear Timer delay program:
NOTE: Air conditioner can be either on or off. Press and hold TIMER for 3 seconds. Timer indicator light will shut off.

To select the mode:
Press AUTO COOL, COOL, FAN ONLY, or POWER SAVER. s Auto Cool�fan speed is adjusted automatically.
s

To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Hour indicator light will turn on, and display will show remaining time. 2. While the display is showing the remaining time, you can press the plus or minus button to increase or decrease the time. 3. After 10 seconds, Hour indicator light will turn off, and Room indicator light will turn on. Display will show the current room temperature.

Cool, Fan Only or Power Saver�you can adjust the fan speed.

9