PIONEER XW-HTD525/MYXJ
Manual de Servicio

1

2

3

4

A

B

1 CHANNEL INDICATORS Light to indicate the selected channel. 2 CHANNEL In case of poor reception due to interference from other electrical devices, you can improve reception by selecting another channel. Each time you press the button, the channel changes sequentially:

7 STEREO MODE VOLUME Turn to adjust the speaker volume when the WIRELESS MODE is set to W.STEREO. The STEREO MODE VOLUME control has no effect when set to W.SURROUND. Use the receiver volume control to adjust the speaker volume. 8 POWERindicator Lights when the wireless speaker is switched on. 9 TUNEDindicator Lights when the signal from the transmitter is properly received. 10 AUDIO LEVEL Turn to adjust the wireless speaker volume.

CH 1

CH 2

CH 3

CH 4

� Poor reception may cause the audio to be interrupted or stopped. This is not malfunction. Try changing the location or orientation of the transmitter and/or the wireless speaker to improve reception. � The wireless speaker can be used at distances of up to 10m from the transmitter. This range may change depending on the environment. 3 Transmitter antenna Transmits signals to the wireless speaker. 4 Wireless speaker antenna Receives signals from the transmitter. 5 POWER Press to switch the unit on or off. 6 WIRELESS MODE switch Slide to either select W.SURROUND or W.STEREO mode. W.SURROUND - Sounds going to the surround left and right channels are heard through the wireless speakers.

Changing the volume with W.SURROUND
When W.SURROUND is selected, you can control the level of the wireless speaker by adjusting the LS and RS channel levels as necessary for balanced surround sound. [VSX-C402] Refer to the section on Setting individual channel level in the receiver�s operating instructions. [VSX-D514] Refer to the section on Setting the relative volume level of each channel in the receiver�s operating instructions. [VSX-D514 only] You can also use the signal converter AUDIO LEVEL control to adjust the wireless speaker volume.

C

D

W.STEREO - The wireless speaker can be
used as a second stereo speaker system (which will output the same stereo signal as the main system) when you use this setting with the 5-STEREO mode on the receiver. You will be able to adjust the sound of this speaker independently using the STEREO MODE VOLUME control (see below). When set to W.SURROUND, the STEREO MODE VOLUME control does not function.

� When setting up the receiver, make sure the surround speakers are set to S(small). Settings larger than S will result in lower frequency distortion in sources that have a lot of bass.

E

F

6
1 2

XW-HTD525
3 4