JVC XVS45GD
Manual de Servicio

XV-S40BK/XV-S42SL/XV-S45GD/XV-S30BK
Removing the traverse mechanism assembly (See Fig.4 and 5)
Prior to performing the following procedure, remove the clamper assembly and the tray. 1. Remove the four screws B attaching the traverse mechanism assembly. ATTENTION: Before reattaching the traverse mechanism assembly, pass the card wire extending from the spindle motor board through the notch d of the elevator.

B
Traverse mechanism assembly

B

B
Fig.4

B

B
Traverse mechanism assembly

B
Removing the elevator (See Fig.6 and 7)
Prior to performing the following procedure, remove the clamper assembly, the tray and the traverse mechanism assembly. 1. Extend each bar e inside of the loading base outward and detach the elevator shaft. ATTENTION: When reattaching, first fit the two shafts on the front of the elevator to the slots f of the slide cam. Fig.5
Elevator e

Elevator Notch d

Shafts Elevator Elevator

Slide cam

Elevator

Loading base Slots f e

Fig.7

Fig.6

1-9