JVC XV-M557GDUX
Manual de Usuario

Getting started

To connect to audio equipment with a digital input
You can enhance the sound quality by connecting the unit�s DIGITAL OUT (optical) to the digital input of an amplifier, DAT or MD by using an optional digital cable. The digital stereo audio signal from a disc is directly transferred. If you connect the unit to a Dolby Digital, DTS or MPEG Multichannel decoder or an amplifier with a built-in decoder by using an optional digital cable, you can enjoy high-quality surround sound. When you make the digital connection, also make the analog connection, because, depending on the disc type, no audio may be reproduced from the DIGITAL OUT. The unit
VIDEO OUT VIDEO S-VIDEO Y COMPONENT PB PR

AV COMPU LINK
VIDEO OUT SELECT
NTSC PAL

AUDIO OUT
L

DIGITAL OUT PCM/STREAM
OPTICAL

ATTENUATOR
OFF ON

R

Optical digital cable (not supplied) Digital equipment

Red

White

White

IN
LEFT

IN AUDIO DIGITAL
OPTICAL

Red

Audio cable (not supplied) � For digital connection, connect the unit�s DIGITAL OUT (optical) to the digital input of audio equipment using an optional digital cable.

NOTES
� When you connect the unit's DIGITAL OUT to digital audio equipment, before using, make the �DIGITAL AUDIO OUTPUT� setting in the �AUDIO� page of the preference display correctly according to the connected audio equipment. If the �DIGITAL AUDIO OUTPUT� is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See �DIGITAL AUDIO OUTPUT� on page 43. � With the digital connection, the unit�s settings for COMPRESSION and DOWN MIX in the AUDIO page of the preference display are invalid. Settings for these items must be made from the decoder.

To connect the power cord
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the unit�s AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The STANDBY indicator lights and setup is completed. Getting

Warning
� � � � � Disconnect the power cord if you are not going to use the unit for a long time. Disconnect the power cord before cleaning the unit. Disconnect the power cord before moving the unit. Do not connect or disconnect the power cord with wet hands. Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents.

Caution
� Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents. � To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the cord is damaged, contact a dealer and get a new power cord. � Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.

14

started

RIGHT