SECTION 2 Disassembly method
2.1 Main body 2.1.1 Removing the top cover (See Fig.1) (1) Remove the four screws A on each side of the body. (2) Remove the two screws B on the back of the body. (3) Lift the rear part of the top cover and remove in the direction of the arrow while pulling both sides of the top cover outward.
Fig.1 2.1.2 Removing the front panel assembly (See Fig.2 and 3) � Prior to performing the following procedure, remove the top cover. (1) Disconnect the card wire from connector CN801 and CN803 on the servo control board, and CN951 on the power board respectively. (2) Remove the three screws C on the upper side of the body. (3) Remove the three screws D on the bottom of the body. Remove the front panel assembly toward the front.
