Firstly remove the tray panel to remove the mecha. section. In this section, explain a disassembly of the tray panel.
How to open the tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the LOADING MECHA. Assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
1 2 3 4 5 6
B
Remove the top panel and top plate. (See Step ¥.) Press the STANDBY/ON button to turn on the power.
Press the 0 (OPEN/CLOSE) button to open the tray. Remove the tray panel. Press the 0 (OPEN/CLOSE) button to close the tray. Press the STANDBY/ON button to turn off the power.
Slit
26
4
C
Tray
35
Screwdriver (small)
3
5
Tray panel
7
Disassembly of after step 7, refer to "Step [ DVDM Assy" . Projection
