SONY XTXM1
Manual de Servicio

XT-XM1 SECTION 2 GENERAL
Installingthe unit
�Mount the unit either inside the trunk or under a seat. �Choose the mounting location carefully so the unit will not interfere with the normal movements of the driver and it will not be exposed to direct sunlight or hot air from the heater. �Do not install the unit under the floor carpet, where the heat dissipation from the unit will be considerably impaired. First, place the unit where you plan to install it, and mark the positions of the four screw holes on the mounting surface. 1 1

This section is extracted from instruction manual.

Screw hole: ø3.3 mm (5/32 in.)

Notes � Use only the supplied screws. � Be sure not to damage the fuel tank or brake line with the tapping screws.

Fuse replacement
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction.

Warning
Use a fuse with the specified amperage rating. Use of a higher amperage fuse may cause serious damage.

Connection
Connectionexample Cautions
� This unit is designed for negative ground 12 V DC operation only. � Before making connections, turn the car ignition off to avoid short circuits. � Connect the yellow power input cord only after all other cords have been connected. � Run all ground leads to a common ground point.

XM Antenna*

Sony BUS Compatible Car Audio*

XT-XM1

CD/MD changer*
* not supplied

Connectiondiagram

Connect with BUS cable to the XM Satellite receiver, aligning the v marks.

Note When you use an optional BUS cable, note that a BUS cable with an 8-pin plug (L-type) cannot be used because of its shape.

SONY BUS CONTROL

AUDIO

ANTENNA

POWER

OUT

IN

L

OUT

R

L

IN

R

TER

SAT

Green
2 Connect as the connector hook facing down

Yellow (Curry)
XM antenna (not supplied)

RCA pin cord (not supplied) To a +12 V power terminal which is energized at all times Be sure to connect the black ground lead to it first. Fuse (3 A) Yellow

OUT

CD/MD changer (not supplied)

BUS cable (not supplied) 4

OUT IN

To a metal point on the car First connect the black ground lead, then connect the yellow power input leads.

Black 3 IN

Sony BUS Compatible Car Audio (not supplied)

3