When Carriage 100 drops below, Carriage 200 is lightly lifted by the finger. Note : Lift it horizontally when you lift Carriage. Carriage inclines when it is not the horizontal, and mechanism locks. Bevel Gear is turned clockwise (direction of a rear side from a front side) like the state of 7 . Carriage 200 lifts up. And, when the movement is started Carriage 100 to the direction of a front side, separates the hand which lifted Carriage 200.
8 9
4
Carriage 200
10 4-1 4-2
The other side of the side applied by pushed.
Keeps turning Bevel Gear clockwise (direction of a rear side from a front side) until Carriage 100 bumps to the wall on a front side.
3
of Carriage is lightly
Puts Carriage 100 on Carriage 200 which applies by Be careful about notes by 3 at this time.
4-1 .
5
Bevel Gear is turned clockwise. (direction of a rear side from a front side)
Carriage 100
5
11
The position of a right and left, black cam is matched while confirming it from the table side of Drawer. Surface of Drawer
6
6-1 6-2 6-3
Carriage 200 moves to a front side. Bevel Gear is turned as it is clockwise. (direction of a rear side from a front side) Carriage 100 drops below. Meanwhile, Mark of right and left, black Cam is matched.
