reset
that the machine does not work reset occurs, In such correctly (pressing because the STOP to wrong the MICROCOMPUTER key + POWER key) is not reset is performed. is defective and check good and to or no even though the AC
are cases cord
is re-inserted, described
or the software phenomenon
the above
it can leads perform
judgment
as if the MICROCOMPUTER by the following procedure
exchange good @)
the MICROCOMPUTER.
a case,
the forced-reset
of the MICROCOMPUTER. Remove the AC power cord.
FRONT
C.B
~@vss
*�
15~\
MICRO�-�TTJTER
\
FRONT
o
C.B d
Short
with
tweezers.
Fig-2-2
@ @
Short Connect
the both
ends
of the electrolytic cord again.
capacitor
Cl 13 that
is connected returns
to VDD
of the MICROCOMPUTER operation,
with
tweezers.
the AC power
If the MICROCOMPUTER
to the normal
the MICROCOMPUTER
is good.
Note:
The reference depending
number
or MICROCOMPUTER Be sure to check
pin number the reference
of transistor numbers
(Ql
10) and electrolytic diagram before
capacitor starting
(Cl 13) can change the discharging work.
on the models.
on schematic
2-3.
Confirmation
Check
of soldering
state after
state
of MICROCOMPUTER
in addition the trouble to the above described procedures. Be sure to exchange the
