AIWA XREC11
Manual de Servicio

ELECTRICAL ADJUSTMENT -2/5
5. DC Balance Check Requirement Measuring equipment: Digital multi-meter Test point: TP2, 3 1) Adjust the reception frequency of the main unit to 98.0MHz. 2) Check that the test point voltage difference between TP4 and TP5 is 0mV±500mV.

DIGITAL MULTIMETER V VT GND

<LW / MW ADJUSTMENT> For LW / MW adjustment, do wiring and connection as in the following.
60cm

Standerd Signal Generaor

SET TP Lch Rch GND

Connect to the respective measuring equipment

6. IF Adjustment (MW) Requirement Measuring equipment: Oscilloscope or Millivoltmeter Test point: TP8(Lch), TP9(Rch), GND Adjustment point: L802 1) Adjust the setting of Standard Signal Generator (hereinafter S.S.G.) to 999KHz of 30% variation. 2) Adjust the receiving frequency of the main unit at 999KHz. 3) While looking at the waveform on the oscilloscope, reduce the output level all the way (till a certain degree of is monitored through the oscilloscope). 4) Adjust L802 until the waveform of the oscilloscope reaches the maximum. 7. Tracking Adjustment (MW) Requirement Measuring equipment: Millivoltmeter Test point: TP8(Lch), TP9(Rch), GND Adjustment point: L952, L953 1) Adjust the S.S.G. setting to 999KHz of 30% variation and reduce the output level all the way (till a certain degree of is monitored through the oscilloscope). 2) Adjust the reception frequency of the main unit to 999KHz. 3) Adjust L952 until the value of the millivoltmeter reaches the maximum. 4) Adjust the S.S.G. setting to 603KHz of 30% variation and reduce the output level all the way (till a certain degree of is monitored through the oscilloscope). 5) Adjust the reception frequency of the main unit to 603KHz. 6) Adjust L953 until the value of the milivoltmeter reaches the maximum. 7) Repeat the adjustment 2 or 3 times from step 1 to 6 above.

OSCILLOSCOPE

CH1

CH2

GND

Lch Rch GND

AC MILLIVOLTMETER

TP8
GND

CH1

CH2

GND

TP9

-57-