AIWA XPR220
Manual de Usuario

To enter standby mode, press ePLAY/PAUSE to start playback, then press sSTOP/OFF/CHARGE.

Adjusting the sound � G
Volume
Turn the VOL control to adjust the volume.

DSL
Press DSL repeatedly for more powerful sound and deeper bass. : Deep bass is emphasized. : Deep bass is strongly emphasized. : Normal sound

I

Signal sound function

You can check the operation by beep sound when you press an operation button. The signal sound function is activated when you purchase this unit. To use the signal sound function, press ePLAY/PAUSE while pressing PLAY MODE to display � � while in stop mode. The beep sound is heard when you press a button. To cancel the beep sound, repeat this procedure.

Inserting a disc � H
1 Slide the OPEN switch to open the disc compartment. 2 Place a disc in the center with the label side facing up. 3 Close the disc compartment.

To remove the disc � I
Pick up the disc, holding its edge, while pressing the pivot gently.

Note
� The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms. � Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. It may cause malfunction.

XP-R220 (AU) E Page 1