AIWA XP-ER800N
Manual de Usuario

3-252-981-21 (1)

WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.

Battery life* (approx. hours)
E�A�S�S Two Sony alkaline 38 batteries LR6 (SG) (produced in Japan)

(When the CD player is used on a flat and stable place.) Playing time varies depending on how the CD player is used. E�A�S�S 32 Radio ON 58

Button/Switch and its Function/Operation 0 MODE For CD player: Press repeatedly until the play mode you want appears in the display. No indication: Normal play �1�: Single play �SHUF�: Shuffle play �PGM�: PGM (program) play To repeat the play mode you selected, press and hold until � � appears. For radio: Press until �ST� disappears from the display to improve the receiving condition on FM. ! HOLD Use to lock the controls to prevent accidental button presses. @ VOL+/� Press to adjust the volume.

To check the program

During programming, press ENTER/DISPLAY repeatedly before step 5. Each time you press ENTER/DISPLAY, the track number appears.

Note
� When you finish entering the 24th track in step 3, the first selected track appears in the display. � During the PGM play, you cannot check the program.

TV/WB/FM/AM Portable CD Player
Operating Instructions

To prevent fire, do not cover the ventilation of the apparatus with newspapers, tablecloths, curtains, etc. And don�t place lighted candles on the apparatus. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus.

* Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association).

To cancel PGM play
During programming or PGM play, press MODE once so that �PGM� disappears.
(Continue to the reverse side)

To check the remaining power of the batteries
You can check it in the display. Replace the batteries when � Lo batt*
* Beep sounds.

CAUTION

The use of optical instruments with this product will increase eye hazard. Certain countries may regulate disposal of the battery used to power this product. Please consult with your local authority.

� flashes.

* If the sound is distorted when using the SOUND function, turn down the volume.

CAUTION

Notes
� The indicator sections of roughly shows the remaining battery power. One section does not always indicate one-fourth of the battery power. � Depending on operating conditions, the indicator sections of may increase or decrease.

To protect against sound skipping

XP-ER800N
Sony Corporation ©2003 Printed in China

http://www.aiwa.com/

� INVISIBLE LASER RADIATION WHEN OPEN � DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENT The validity of the CE marking is restricted to only those countries where it is legally enforced, mainly in the countries EEA (European Economic Area).

The E�A�S�S function has been developed to provide excellent protection against sound skipping during many active uses.

Notes on using the dry batteries
� Be sure to remove the AC power adaptor. � When the batteries are depleted, replace both batteries with new ones.

1 Insert a disc and wait until the display goes off. 2 While holding MODE, press ca. 3 Press MODE to select the E�A�S�S mode.
When you select �E�A�S�S�, the E�A�S�S function is enhanced compared to �E�A�S�S �. To walk with the CD player and enjoy high quality CD sound using the E�A�S�S function, select �E�A�S�S �. While taking harder exercises, it is recommended that you set it to �E�A�S�S.�

CD player (front)
1ENTER/DISPLAY 2PRESET CALL UP/DOWN 3BAND 4SOUND 567 s(stop)/OFF/CHARGE Strap holes Display 8r/t SKIP/SEARCH 9ca* 0MODE DC IN 4.5 V (external power input) jack \ (headphones) jack !HOLD @VOL +*/�
*The button has a tactile dot.

Owner�s Record
The model number and the serial number are located at the rear of the CD player. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Aiwa dealer regarding this product. Model No. XP-ER800N Serial No.

Notes on the rechargeable batteries
� To keep the original battery capacity for a long time, charge the batteries only when they are completely depleted. � If the battery is new or has not been used for a long time, it may not be charged completely until you charge and discharge it several times. � When carrying the rechargeable batteries, use the battery carrying case supplied with the rechargeable batteries to prevent unexpected heat. If the rechargeable batteries and the metallic objects get contacted, heat or fire may occur due to a short circuit.

4 Press ENTER/DISPLAY.
Note
Sound may skip: � if the CD player receives stronger continuous shock than expected, � if a dirty or scratched CD is played or � when using poor-quality CD-Rs/CD-RWs or if there is a problem with the recording device or application software.

For the customers in the USA
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: � Reorient or relocate the receiving antenna. � Increase the separation between the equipment and receiver. � Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. � Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Declaration of Conformity Trade Name: AIWA Model No.: XP-ER800N Responsible Party: Sony Electronics Inc. Address: 680 Kinderkamack Road, Oradell, NJ 07649 USA Telephone No.: 201-930-6973 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

A
OPEN

When to replace the rechargeable batteries
If the battery life becomes shorter by about half, replace the batteries with new rechargeable batteries.

Checking the remaining time on the CD and the number of tracks left
You can check the remaining time on the CD and the number of racks left using ENTER/DISPLAY.

To use the AC power adaptor (C) 1 Connect the commercially-available AC power
adaptor whose rated output is 4.5 V DC, 500 mA, to an AC outlet.

1 Press ENTER/DISPLAY.
Each time you press the button, the display changes as follows: Display Normal play Track number and elapsed playing time

Playing a CD
Press ENTER/DISPLAY once.

Display

Track number/PRESET number

Play mode

To insert a CD 1 Slide OPEN to open the lid (A). 2 Fit the CD to the pivot, then close the lid (D).
Notes
� This CD player can play discs recorded in the Compact Disc Digital Audio (Audio CD) format. � This CD player can play CD-Rs/CD-RWs recorded in the Compact Disc Digital Audio (Audio CD) format, but playback capability may vary depending on the quality of the disc and the condition of the recording device. � This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. Track number and remaining time on the current track. Press ENTER/DISPLAY once again. The number of tracks left and remaining time on the CD* *Not displayed during the Single play and Shuffle play.

Sound mode

Remaining battery power

PRESET

VOL

CHG

To remove the CD
Remove the CD while pressing the pivot.

ST

Band

Playing time/ Frequency

E�A�S�S

Power Sources
To use the batteries (B)
Use only the following batteries for your CD player:

To operate the CD player
Button/Switch and its Function/Operation 1 ENTER/DISPLAY Press to check the remaining time on the CD and the number of tracks left. Also press to enter the selected track for the PGM play. 2 PRESET CALL UP/DOWN Press to select the preset station you want. 3 BAND Press to turn on the radio. Press also to change the band. 4 SOUND Use to emphasize the bass-boosted sound. Press repeatedly to select or . enhances more than .* 5 s(stop) Press to stop playing. 6 OFF Press to turn off the radio. 7 CHARGE Press to start charging. 8 r/t (skip/search) For CD player: Press r or t once to find the beginning of the current/next track. Press r or t repeatedly to find the beginning of the previous/ succeeding tracks. Press and hold r or t to go backward/forward quickly. For radio: Press to tune in the station you want. 9 ca (play/pause) Press to start play. Press again to pause play. To play from the first track, press for 2 seconds or more while the CD player is stopped.

B

Dry batteries

� LR6 (size AA) alkaline batteries (not supplied)

To turn off the operation beep sound
You can turn off the beep sound that is heard from your headphones when you operate your CD player.

Rechargeable batteries
Charge the rechargeable batteries before using them for the first time. � Commercially-available size AA Ni-MH rechargeable batteries of 1.2 V DC, 700 mAh

1 Remove the power source (AC power adaptor, dry
batteries) from the CD player, and wait for about 3 seconds.

To insert the batteries
Open the battery compartment lid. Insert the ( end first (for both batteries).

2 Connect the power source while pressing s/OFF/
CHARGE.

1 Open the battery compartment lid on the rear of your CD
player.

To turn on the beep sound
Remove the power source, wait for about 3 seconds, and then connect the power source without pressing s/OFF/ CHARGE.

2 Insert two batteries by matching the ) to the diagram
in the battery compartment and close the lid until it clicks into place.

C
DC IN 4.5V

to an AC outlet

3 When using the rechargeable batteries, connect the

D
Label side up

commercially-available AC power adaptor to the DC IN 4.5V jack of your CD player and an AC outlet, then press s/OFF/CHARGE while the CD player is turned off to start charging. The CD player charges the batteries. The �CHG�

Playing tracks in your favorite order (PGM play)
You can program the CD player to play up to 24 tracks in your favorite order.

AC power adaptor

indicator turns on in the display and the the indicator sections of light up in succession. When the batteries are completely charged, the �CHG� and indicators get turned off. If you press s/OFF/CHARGE after the charge has

1 During playback, press MODE repeatedly until
�PGM� flashes.

2 Press r or t to select a track. 3 Press ENTER/DISPLAY to enter the selected track.
�00� appears and the playing order increases by one.

\

already been completed, the indicator flashes and �Full� appears in the display.

4 Disconnect the AC power adaptor.

4 Repeat steps 2 and 3 to select the tracks in your
favorite order.

5 Press and hold ENTER/DISPLAY until the PGM play
starts.

Headphones