ROLAND XP-60
Manual de Usuario

Pan B (Output pan B) Adjust the stereo location of the Pitch Shift B sound. L64 is far left, 0 is center, and 63R is far right. Pre Delay B (Pre delay time B) Adjust the time delay from when the direct sound begins until the Pitch Shift A sound is heard. Mode (Pitch shifter mode) Higher settings of this parameter will result in slower response, but steadier pitch. Level Balance Adjust the volume balance between the Pitch Shift A and Pitch Shift B sounds. Balance (Effect balance) Adjust the volume balance between the direct sound and the processed sound.

Balance (Effect balance) Adjust the volume balance between the direct sound and the processed sound. Level (Output level) Adjust the output level.

24: REVERB
The Reverb effect adds reverberation to the sound, simulating an acoustic space.
L in
Balance D

2-Band EQ
Balance W

L out

Reverb
Balance W

R in
Balance D

2-Band EQ

R out

Type (Reverb type) Level (Output level) Adjust the output level. Select the type of Reverb effect. ROOM1 : dense reverb with short decay ROOM2 : sparse reverb with short decay STAGE1 : reverb with greater late reverberation STAGE2 : reverb with strong early reflections
L in
Balance D

23: FBK-PITCH-SHIFTER (Feedback pitch shifter)
This pitch shifter allows the pitch shifted sound to be fed back into the effect.
2-Band EQ
Balance W

L out

HALL1 : reverb with clear reverberance HALL2 : reverb with rich reverberance Pre Delay (Pre delay time)

Pitch Shifter R in
Feedback Balance D Balance W

2-Band EQ

R out

Adjust the time delay from when the direct sound begins until the reverb sound is heard.

Coarse (Coarse pitch) # Adjust the pitch of the pitch shifted sound in semitone steps (-2�+1 octaves). Fine (Fine pitch) Make fine adjustments to the pitch of the pitch shifted sound in 2-cent steps (-100�+100 cents). Pan (Output pan) Adjust the stereo location of the pitch shifted sound. L64 is far left, 0 is center, and 63R is far right. Pre Delay (Pre delay time) Adjust the time delay from when the direct sound begins until the pitch shifted sound is heard. Mode (Pitch shifter mode) Higher settings of this parameter will result in slower response, but steadier pitch. Feedback (Feedback level) # Adjust the proportion (%) of the processed sound that is fed back into the effect. Negative (-) settings will invert the phase. Low Gain Adjust the gain of the low frequency range. High Gain Adjust the gain of the high frequency range.

Time (Reverb time) # Adjust the time length of reverberation. HF Damp Adjust the frequency above which the reverberant sound will be cut. As the frequency is set lower, more of the high frequencies will be cut, resulting in a softer and more muted reverberance. If you do not want the high frequencies to be cut, set this parameter to BYPASS. Low Gain Adjust the gain of the low frequency range. High Gain Adjust the gain of the high frequency range. Balance (Effect balance) # Adjust the volume balance between the direct sound and the processed sound. Level (Output level) Adjust the output level.

Chapter 3. Creating your own sounds

83