Removing the rear panel (See Fig.6 and 7)
� Prior to performing the following procedure, remove the top cover.
Rear panel
C
C
1. Remove the three screws E attaching the rear panel on the back of the body and release the two joints "c" on both sides while moving the rear panel upward.
E Fig. 6 Wire stopper
2. Disconnect the harness from connector CN833 on the signal input/output board. (When disconnecting the harness from the rear panel, unhook the upper and lower four hooks of the wire stopper on the back of the rear panel and pull out the harness outward.)
CN833
Signal input/output board Fig. 7
CAUTION: Lift the lock and pull out the wire.
CN833 Fig.7-1
Removing the signal input/output board (See Fig.8)
� Prior to performing the following procedure, remove the top cover and the rear panel. 1. Disconnect the harness from connector CN831 and CN832 on the signal input/output board.
Signal input/output board
F CN831 CN832 F F
2. Remove the four screws F attaching the signal input/output board.