XL-R5020BK 3.1.8 Removing the traverse mechanism assemb ly (See Fig.26) *Prior to performing the following procedure, remove the servo control board and the clamper base unit. (1) Remove the three screws K attaching the traverse mechanism assembly. (2) Detach the rear part of the traverse mechanism assembly upward to release the joint o with the sub chassis unit. Then remove the assembly from the body.
Fig.26 3.1.9 Removing the feed motor (See Fig.27) *Prior to performing the following procedure,remove the traverse mechanism assembly. (1) Remove the screw L attaching the feed motor.