|
Usuarios conectados
Actualmente hay 5813 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
20 EN
INITIAL SETTINGS (cont.)
CH
7 8
ACCESS DBS RECEIVER BRAND SET SCREEN
Press OK.
SET DBS RECEIVER BRAND
Press the appropriate NUMBER keys to enter the DBS Receiver Code from the following list, then press OK.
DBS RECEIVER BRAND SET 40
PRESS NUMBER KEY (0�9) THEN (OK) TO TEST PRESS (MENU) TO END
1
T
2 5 8 0
W
3
2
BRAND JVC (DISH Network) ECHOSTAR (DISH Network) PRIMESTAR SONY (DSS) RCA (DSS)
CODE 51 51 50 41 40
NUMBER
4 7
6 9
4
1
DV
VHS
� After OK is pressed, the program currently received through the DBS receiver will appear for about 10 seconds. � If the DBS receiver's channel changes to the channel listed below for your brand of DBS receiver, setting is complete. Press OK and "DBS RECEIVER CONTROL IS ON" appears on the screen for about 5 seconds, then it returns to the normal screen. JVC [ 100 ECHOSTAR [ 100 PRIMESTAR [ 55 SONY [ 205 RCA [ 205 � If the DBS receiver's channel does not change as shown above, press CH 5� or %� to move the highlight bar (arrow) to "NO", then press OK. Reenter the correct code.
3
O
NOTES:
K
� It is possible that the Controller will not work with all types of DBS receiver. � If your DBS receiver doesn�t respond to the code, you can�t use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording. � The VCR can only change the satellite channel through the Controller during timer recording. � If your DBS receiver is one that can�t be operated with a remote control (because it has no remote sensor), you can�t use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start of timer recording. � If you are unable to set the Controller, please contact JVC toll free at 1-800-252-5722.
|
|
|
> |
|